GiE11
-
Content Count
9 -
Joined
-
Last visited
Posts posted by GiE11
-
-
I have just found an article that describes my problem. The solution my be to put the SC-P600 printer in service mode before installing tehe ink firmware. I really would like to try that. Would it be possible for you to reset my key one more time so that I can try the installation in service mode?
-
The Problem is that the printer beeps and Shows the error message that the cartridges could not get recognized at every first print after powering off the printer. As soon I open and close the cartridge case the cartridges get recognized again and the printer prints out correctly. (see Pictures)
-
On 5/24/2018 at 4:45 PM, John_Admin said:Firmware version is right
We can renew your key and you can try upload firmware once more time
now I have tried another time. I have used exactly the manual of your website but have still the same result. At the first print after I have switched off/on the printer I get an error message that the cartridges can not get recognized. I have to open/close the cartridge box so that the printer recognize the cartridges again and start the print. The status of the cartridges Shows always 100% full.
Can you Help me to get this fixed?
-
On 5/24/2018 at 4:45 PM, John_Admin said:Firmware version is right
We can renew your key and you can try upload firmware once more time
I still get the message "You cannot use this key anymore because it has been already used on 2018-05-18 22:21:09. You need a new key". Can you please let me know how I can get the renewed key?
-
can you please let me know how I can get the renewed key? When I check my key I get the error message that this already has been used.
-
That sounds good. Thanks in advance! I am looking forward to gat an other key via Email so that I can try again.
-
My current firmware version is AT12GC
-
I have done the downgrade my SC-P600 to chipless mode. Almost everything works fine but at the first print after I have switched off/on the printer I get an error message that the cartridges can not get recognized. I have to open/close the cartridge box so that the printer recognize the cartridges again and start the print. The status of the cartridges shows 100% full. Is there any solution so that I can print after switchting off/on the printer without any error?
Epson SC-P600 Chipless firmware
in Firmware with disabled ink cartridges
Posted · Report reply
now I have tried the FW-Change in Service mode of the SC-P600 printer. Unfortunately I have the same result as before. Every first print the printer shows the error message that the cartridges can not get recognized by the printer. After opening/closing the cartridge case the printer recognize the cartridges and prints fine.
Do you have any idear how to fix that so that printer does not come up with the error message?