Jump to content
WIC Reset Program and Chipless Firmware

jlb

Members
  • Content Count

    6
  • Joined

  • Last visited

Community Reputation

0 Neutral

About jlb

  • Rank
    Newbie
  1. isn't the whole point of using the firmware so that you can use refillable cartridges? I'm using quality ink. After one round of a head clean and ink charge, one cartridge will print fine, but others wont. After the next round of clean and charge, the ink that worked fine before now is missing dots in the nozzle test and a different cartridge prints. The software (to clean and charge) is obviously doing something because it prints differently each time.
  2. John_Admin, I have done printhead cleaning, and ink charge several times. The position of the missing dots change, but still won't fully print. I've had to replace a cartridge three times since I purchased your firmware. The first two times, I had to keep repeating this process 20-30 times. It finally started printing but this process used up about 1/2 of the ink. I've just had to replace a third cartridge and I've run the printhead cleaning and ink charge about 20-30 times and it's still not printing well. Dots are still missing and ink is being wasted. What can I try next?
  3. same here. I didn't check the page count. Would the firmware have code in it to not release ink if the page count is at a certain number? I just installed full ink cartridges but I only get a few dots on the page when printing a document. I've tried a print head nozzle check. Same think. Only prints a few dots.
  4. I have the same problem Stephanie has with the nozzle check not printing anything, other than a few dots here an there. So obviously, everything I print looks like a blank page. Worked great the first time I installed the firmware. But as soon as I had to replace the empty cartridges, it won't pull out any ink to print. I have a WF-4730
×
×
  • Create New...