Jump to content
WIC Reset Program and Chipless Firmware
Sign in to follow this  
Pabloalbo1991

Xp-431 reading failed - 1

Recommended Posts

I have the solution for reading failed -1 problem
1.- Put the printer in recovery mode. To put in recovery mode you must load the firmware and when I start writing the printer you turn it off before it finishes.
2.- When in recovery mode, upload the firmware to the printer from your pc. When charging is complete, the printer will turn itself off.
3.- You turn on and apply the activator "license" and voila !!!

It works perfectly .....

I hope it works for you !!! any questions write me ....

Share this post


Link to post
Share on other sites

We use the method without service mode and it reaches 14% then it sends an error indicating that the firmware is not installed.

Share this post


Link to post
Share on other sites

This means that either USB cable is damager or more likely, that printer has some error (for example ink out error).

Unfortunatelly, for some models update process is only possible if printer is ready to print (i.e. it does not show ink out error or any other errors at all). For such printer recognizable ink cartridges or suitable alternative must be installed while it is updating. If it is not possible, you may try to update it first using service mode and if it fails, try this method. The affected printers are:

XP-211 XP-212 XP-213 XP-214 XP-216 PX-046A
XP-230 XP-231 XP-235 PX-048A
XP-430 XP-431 XP-434

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...