Jump to content
WIC Reset Program and Chipless Firmware
Philipp

supported models

Recommended Posts

I'm looking for the support of your WIC-Reset program for the Canon PIXMA TS8150
Your trial version find the model TS8150, but give the massage this model is not supported.

Is there any chance to get your software for my model in future ?


and how can I get in service mode, because my printer have ONLY the power on/off pushbutton and no other buttons
best regards Phil

Share this post


Link to post
Share on other sites

Good day. We can add support for this series using your printer and reset it in the process, if you are interested, I will send you contact information in the PM. As for the service mode, we do not have this model but presumably you need to press the area on the LCD where stop button is normally shown.

Share this post


Link to post
Share on other sites
On 4/18/2023 at 12:49 PM, wic.support said:

Good day. We can add support for this series using your printer and reset it in the process, if you are interested, I will send you contact information in the PM. As for the service mode, we do not have this model but presumably you need to press the area on the LCD where stop button is normally shown. https://studyhelper.com/argumentative-essay-samples

Thanks a lot! 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...