Jump to content
WIC Reset Program and Chipless Firmware

JosephSmith

Members
  • Content Count

    7
  • Joined

  • Last visited

Community Reputation

0 Neutral

About JosephSmith

  • Rank
    Newbie
  1. Yes, I am considering it, but I wasn't sure it was OK. I haven't found about this in the website or forum. Thank you for your attention.
  2. Hey, yes it was activated successfully and it shows 100% ink, BUT when I need to refill them or change a cartridge, it doesn't show 100% and it shows up an error, as I said, and I can't print anymore before turning it off. My original question is, what to do to print after changing a cartridge/refilling, do I MUST have to turn the printer off and back on? There is no way to recognize all cartridges as 100%, faster than turning it off? Is that working as expected after using the activation key? Thanks
  3. Hi I did the step by step I said above, there is no other step. The problem is to recognize as 100% after refilling a cartridge or changing any cartridge. Do i have to TURN THE PRINTER OFF every time I change/refill any cartridge?? Thanks
  4. Good day too, So, I did it: 1) I held the red button until the cartridges get in the change position 2) Got the cartridges out and back in 3) pressed the red button until cartridges got to the inside position 4) it shows the "ink drop" led steady on, and if I press the red button again and again it stops at each of the 4 cartridges. WICReset Status: Status Ink out error Black Unavailable Yellow Unavailable Magenta Unavailable Cyan Unavailable My question is: how can I change or refill them and it shows 100% again? Do I have to turn the printer off every time? Thank you.
  5. I've already activated my printer with the Chipless firmware and License. How can I keep printing after taking the cartridge out and putting it back refilled in the EPSON XP-241? It shows an error, can I use a sequence of buttons? Do I must have to turn it off and back on? The cancel red button didn't do it
  6. Hi,

    I've already activated my printer with the firmware and license.

    How can I keep printing after taking the cartridge out and putting it back refilled in the EPSON XP-241? It shows an error, can I use a sequence of buttons? Do I must have to turn it off and back on? The cancel red button didn't do it.

    Thanks.

×
×
  • Create New...