Jump to content
Printer Reset Forum

Hamset

Members
  • Content Count

    11
  • Joined

  • Last visited

Community Reputation

0 Neutral

About Hamset

  • Rank
    Member

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. the classic error "your printer pads have reached their limit" contact technical support
  2. the printer is practically new, has less than 100 prints, because it is blocked?
  3. I already installed the firmware without a chip. The problem is that the printer after a few prints is blocked by pads and does not allow me to reset them.
  4. after the installation of this firmware system the printers to the few limitations of the head are blocked, which is normally not complicated since there are programs available to reset, however these resetters do not work with the modified firmware, any option?
  5. We use the method without service mode and it reaches 14% then it sends an error indicating that the firmware is not installed.
  6. It does not have cartridges installed but the error it gives is it reads 1. 4 days ago I activated another xp231, it gave an error regarding the internet, it linked the internet of the cell phone and it worked well. That machine was active (it did not have cartridges either).
  7. Model Name XP-230 Series Status Ink out error Firmware ver. FO04JA 04/10/2019 Serial Number W2HK041578 Print Head ID 09F64537BUUUP04 Manual cleaning counter 4 Timer cleaning counter 3 Ink replacement cleaning counter 2 Total print pass counter 39841 Total print page counter 626 Total scan counter 315 First TI received time 11/08/2016 Ink replacement counter - black 2 Ink replacement counter - cyan 1 Ink replacement counter - magenta 1 Ink replacement counter - yellow 1 Last printer fatal error code 1 0xEA CR LOAD POSITION excess load error. CR encoder failure. CR motor failure. Carriage overload. Tooth skip or improper tension of the timing belt. Cable or FFC disconnection. Last printer fatal error code 2 0xF1 PF PID excess load error. Encoder failure. PF motor failure. PF Mechanism overload. Cable or FFC disconnection. Tooth skip or improper tension of the timing belt. Cable or FFC disconnection. Motor driver failure. Main board failure. Last printer fatal error code 3 0xF1 PF PID excess load error. Encoder failure. PF motor failure. PF Mechanism overload. Cable or FFC disconnection. Tooth skip or improper tension of the timing belt. Cable or FFC disconnection. Motor driver failure. Main board failure. Last printer fatal error code 4 0xF1 PF PID excess load error. Encoder failure. PF motor failure. PF Mechanism overload. Cable or FFC disconnection. Tooth skip or improper tension of the timing belt. Cable or FFC disconnection. Motor driver failure. Main board failure. Last printer fatal error code 5 0x00 Fatal error does not occur. Last scanner fatal error code 1 0x10 Scanner/ADF home position detection error. CIS Module failure. Scanner housing upper failure (home seek pattern is dirty). Scanner housing lower failure (the rack section is damaged). Scanner motor failure. Insufficient grease. Foreign object. Cable or FFC disconnection. Main board failure.
  8. exactly the same thing happens to me as in this case I have activated several machines from this computer, in fact yesterday I activated an xp231, the problem is with this other one that apparently has the updated firmware. An xp241 gave me exactly the same fault and I solved it with the new firmware that they exposed in the other post that I attached in this message
  9. firmware error, reading 1 (Is there a solution equal to xp241?)
  10. Hello, I have the same problem with the xp 231 model
×
×
  • Create New...