Jump to content
Printer Reset Forum
Sign in to follow this  
guigs199

Epson xp 241 - FATAL ERROR

Recommended Posts

Hi, i'm having this error on my xp 241, anyone knows what i need to do to fix it?

Thanks

Model Name    XP-240 Series    
    Status    Fatal error    
    Firmware ver.    MF07I3 07/03/2018    
    Serial Number    X2CW021852    
    Print Head ID    3988E68N0M    
    Manual cleaning counter    16    
    Timer cleaning counter    1    
    Ink replacement cleaning counter    0    
    Total print pass counter    2112    
    Total print page counter    39    
    Total scan counter    11    
    First TI received time    18/03/2018    
    Last printer fatal error code 1    0x80E9 Blowout of a fuse (CRCM).    
    Last printer fatal error code 2    0x80E9 Blowout of a fuse (CRCM).    
    Last printer fatal error code 3    0x80E9 Blowout of a fuse (CRCM).    
    Last printer fatal error code 4    0x80E9 Blowout of a fuse (CRCM).    
    Last printer fatal error code 5    0x80E9 Blowout of a fuse (CRCM).    
    Last scanner fatal error code 1    0x10 Scanner/ADF home position detection error. CIS Module failure. Scanner housing upper failure (home seek pattern is dirty). Scanner housing lower failure (the rack section is damaged). Scanner motor failure. Insufficient grease. Foreign object. Cable or FFC disconnection. Main board failure.    
    Last general fatal error code 1    0x00 Fatal error does not occur.    
    Last general fatal error code 2    0x00 Fatal error does not occur.    
    Last general fatal error code 3    0x00 Fatal error does not occur.    
    Last general fatal error code 4    0x00 Fatal error does not occur.    
    Last general fatal error code 5    0x00 Fatal error does not occur.    

Obs: this happened becouse i disconnected the flat cable that goes in the back of the cart, and had a hard time to put it back. Anyone knows what that flat cable do?
 

Share this post


Link to post
Share on other sites

I have disconnect and connect those cables (scanner ones), every time that i open the printer to check if its all ok.
But it still dont work.
I dont know what that cable that go on the back of the cart do, but i think that cable broke while i was trying to put it on, thats why i want to know what that cable do.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×
×
  • Create New...