Hamset 0 Report post Posted April 16, 2020 after the installation of this firmware system the printers to the few limitations of the head are blocked, which is normally not complicated since there are programs available to reset, however these resetters do not work with the modified firmware, any option? Share this post Link to post Share on other sites
John_Admin 390 Report post Posted April 16, 2020 If You want to change printers firmware to make it chipless - please follow Step by Step Guide - http://www.2manuals.com/product_info.php?cPath=107&products_id=1834 Share this post Link to post Share on other sites
Hamset 0 Report post Posted August 25, 2020 I already installed the firmware without a chip. The problem is that the printer after a few prints is blocked by pads and does not allow me to reset them. Share this post Link to post Share on other sites
John_Admin 390 Report post Posted August 25, 2020 Use WIC utility to reset waste ink counters Share this post Link to post Share on other sites
Hamset 0 Report post Posted August 26, 2020 the printer is practically new, has less than 100 prints, because it is blocked? Share this post Link to post Share on other sites
John_Admin 390 Report post Posted August 26, 2020 give us screenshot of error please Share this post Link to post Share on other sites
Hamset 0 Report post Posted August 30, 2020 the classic error "your printer pads have reached their limit" contact technical support Share this post Link to post Share on other sites
wic.support 31 Report post Posted August 30, 2020 Please, install WICReset, click `report` button in the main interface and post screnshot of this report here. Share this post Link to post Share on other sites
