Jump to content
WIC Reset Program and Chipless Firmware
morris

epson L1455/ et 16500 starts in "printer inspection mode"

Recommended Posts

my epson printer L1455 main board got spoilt, then i bought another one. the one i bought is recognized as Et 16500 series, but it starts in inspection mode, what can i do for the printer to start normally to start working again

IMG-20210424-WA0010.jpg

Share this post


Link to post
Share on other sites

This most likely means that motherboard has not been initialized, you need to either write initial settings via ajp or find eeprom from another L1455 and write it to the printer. In both cases you will also need to set all other printer's settings again.

Share this post


Link to post
Share on other sites

thank you for your reply. how ever i realized the printer board is et 16500 model. is it possible to make the board start reading L1455 ?

Share this post


Link to post
Share on other sites

Both L1455 and ET-16500 use the same firmware, difference is in the data that located in the eeprom.

So the answer stays the same, you either need to write initial settings or copy eeprom data from another device.

Share this post


Link to post
Share on other sites

thanks alot. worked fine with eeprom from another printer. the writing of initial settings is not active with tje adjustment programme am using. i dont know why

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...