triought 0 Report post Posted November 9, 2019 Hello! I ran the Epson license tool and followed the guide and everything seemed to work right but I'm getting a low ink warning. I haven't changed the cartridge as I just filled it.. Is there something I'm missing or did the update not take correctly? Share this post Link to post Share on other sites
John_Admin 390 Report post Posted November 9, 2019 Give us screenshot of License.exe utility after you enter Activation Key What message do you get? Share this post Link to post Share on other sites
triought 0 Report post Posted November 9, 2019 Serial:X46R020396 ID Code: hWKSxNc1k+qEoI3saEngkJ7LXNF0AG9Rptvms0kV6VJu+cFI/rQxA2DOBA19KgzeYmr1nGXM /nasQH2L+bXYLqmoEbYGMf/SGHkX2lawozrbk04aik1SY6EFFJKr7p16DHIBVOFF6aAb/eKr t0Ps9mbbIoYvWoIw6uT8Zc0ffGM= Share this post Link to post Share on other sites
John_Admin 390 Report post Posted November 10, 2019 Give us screenshot of License.exe utility after you enter Activation Key Share this post Link to post Share on other sites
triought 0 Report post Posted November 11, 2019 I think I must of done something wrong. I thought that is what I sent you. I entered the activation key in the software I sent a picture on. Share this post Link to post Share on other sites
triought 0 Report post Posted November 15, 2019 What screen shot besides the one I put above are you needing? it goes through and just gives me that screen and my code is activated but the printer itself still shows ink levels. In the videos it shows that the ink levels are greyed out? Share this post Link to post Share on other sites
John_Admin 390 Report post Posted November 15, 2019 Run License input Activation Key Click Activate button Program will give message give us screenshot Share this post Link to post Share on other sites
triought 0 Report post Posted December 1, 2019 I did a refresh and got this.. Share this post Link to post Share on other sites
wic.support 31 Report post Posted December 1, 2019 Good day. Please, send us screenshot with current ink levels and also try to remove IC completely and start printing what will happen in this case? Share this post Link to post Share on other sites
wic.support 31 Report post Posted September 21, 2020 Chipless firmware for XP-1500 has been updated, reupload firmware and reactivate it with the same key, then tell the results.New firmware can be downloaded from here:https://chiplesssolutions.com/download/chipless/XP15000_FWG150TL_NW07K7_NW99Z9.zip 1 Share this post Link to post Share on other sites